Thursday, 8 May 2014

How to prepare soil for a Garden


1. Choose a location with the essential supplies for the plants you plan to grow. Normally, this will mean exposure to direct sunlight for a minimum of 6 hours each day, and adequate drainage to keep the soil from becoming waterlogged. Also consider possible pests that may visit your garden and help themselves, it might be better to work within a fenced area.

2. Sample the soil material. Basic soils can be sand, sandy loam, loam, loamy clay, and clay. The clay soils do not drain well, and will need loam, sand, or other amendments to allow excess water to drain from them. Sandy soil allows too much water to drain, and will need to be heavily composted or fortified with clay or good topsoil. Garden supply stores can test the soil pH, or acidity, and may recommend adding lime or sulphur to adjust the acid level you specific plants require.

3. Plan the garden layout, allowing room for plants to spread out, vine, or bush as they mature. Watermelons, cucumbers, and squash require lots of space, where onions, radishes, and beets can be grown in smaller spaces. Give yourself room to work, and room for the plants to grow.

4. Strip off the overgrowth from your plot, removing weeds, grasses, and other materials to the clean ground. These can go to the compost pile for later use, but shouldn't be incorporated until they have composted.

5. Turn the soil using a shovel or motor driven rotary tiller as deep as you can. Remember, the roots of your plants will extend deep in the ground to find nutrients and moisture, and by digging or tilling, you loosen the material so they can do so. Remove any large stones or rocks as you work, along with any roots or debris you encounter. You may need to make more than one pass to break up very compacted soils.

6. Add soil amendments, you have determined you will need to balance the PH of the soil and condition it to support good plant growth. This may mean adding compost or topsoil to sand, or sand to heavy clay, and because this varies so greatly from area to area, it may help to talk to a local gardener or county extension agent for advice. Dig or till the garden again to mix in the amendments, as necessary.

7. Smooth the soil with a rake, evening out low and high spots.

8. Fertilize the soil based on plant needs. Too much nitrogen can cause wonderful foliage, but no fruit, and this is not the normal goal of the home gardener

9. Turn the soil and mix it thoroughly one more time after all amendments have been added. Allow the soil to rest for several days, and keep it moist if possible, before planting.

10. Install fences for climbing plants, raise beds where they are helpful, lay out your rows...and plant.

1 comment: